Messages Reference Guide

Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. LC Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
PWR8503
Message The current value of System Input Power Cap (
arg1 AC) is less than the upper limit ( arg2 AC).
Arguments
•
arg1 =
power value
•
arg2 =
power value
Detailed
Description
This Information is provided to enable checking whether the powercap is lower than the
maximum supported powercap limit.
Recommended
Response Action
No response action is required.
Category Audit
SubCategory PWR = Power Usage
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. LC Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
PWR8504
Message Chassis power button is pressed, but the button is disabled.
Detailed
Description
The chassis power button press is detected but the button has been disabled.
Recommended
Response Action
The chassis power button is disabled. To enable the chassis power button use the CMC
RACADM command line interface, CMC Web interface. Using the command line, enter "racadm
config -g cfgChassisPower -o cfgChassisPowerButtonEnable 1". Using the Web interface, click
Chassis Overview > Power > Configuration. Clear the Disable Chassis Power Button check box.
Category Audit
550