Owner's Manual

264 RACADM Subcommands
clrraclog -- clear the CMC log
clrsel -- clear the System Event Log (SEL)
cmcchangeover -- Changes the redundant state of
the CMC from active to standby and vice versa
config -- modify CMC configuration
properties
LEDs on a module
...
setniccfg -- modify network configuration
properties
setractime -- set the time on the CMC
setslotname -- sets the name of the slot in the
chassis
setsysinfo -- set the chassis name and chassis
location
sslcertview -- display a CA/server certificate
in the CMC
sslcsrgen -- generate a certificate CSR from
the CMC
testemail -- test CMC e-mail notifications
testtrap -- test CMC SNMP trap notifications
• racadm ? getsysinfo
getsysinfo -- display general CMC and system
information
Usage:
getsysinfo [-d] [-c] [-A]
-d : show cmc information
-c : show chassis information
-A : do not show headers or labels
arp
NOTE: To use this subcommand you must have Administrator privilege.
Description
Display the Address Resolution Protocol (ARP) table. This table stores the
mapping of IP numbers to MAC addresses of the NICs in the chassis.