Owner's Manual

68 Using the RACADM Command Line Interface
fwupdate Executes or displays status on system firmware updates.
getassettag Displays the asset tag for the chassis.
getchassisname Displays the name of the chassis.
getconfig Displays the current CMC configuration properties.
getdcinfo Displays general I/O module and daughter card
misconfiguration information.
getioinfo Displays general I/O module information.
getkvminfo Displays information about the iKVM.
getled Displays the LED settings on a module.
getmacaddress Displays a server’s MAC address.
getmodinfo Displays module configuration and status information.
getniccfg Displays the current IP configuration for the controller.
getpbinfo Displays power budget status information.
getraclog Displays the CMC log.
getractime Displays the CMC time.
getredundancymode Displays the redundancy mode of the CMC.
getsel Displays the system event log (hardware log).
getsensorinfo Displays information about system sensors.
getslotname Displays the name of a slot in the chassis.
getssninfo Displays information about active sessions.
getsvctag Displays service tags.
getsysinfo Displays general CMC and system information.
gettracelog Displays the CMC trace log. If used with -i, the
command displays the number of entries in the CMC
trace log.
ifconfig Displays the current CMC IP configuration.
netstat Displays the routing table and the current connections.
Table 4-1. RACADM Subcommands (continued)
Command Description