User's Manual

154 Using FlexAddress
The following table lists the status messages returned by the command.
Use the following RACADM command to display all activated features on the
chassis:
racadm feature -s
The command will return the following status message:
Feature = FlexAddress
Date Activated = 8 April 2008 - 10:39:40
Feature installed from SD card SN = 01122334455
Table 6-1. Status Messages Returned by featurecard -s Command
Status Message Actions
No feature card inserted. Check the CMC to verify that the SD card
was properly inserted. In a redundant CMC
configuration, make sure the CMC with the
SD feature card installed is the active CMC
and not the standby CMC.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is
bound to this chassis.
No action required.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is
bound to another chassis,
svctag = ABC1234, SD card
SN = 01122334455
Remove the SD card; locate and install the SD
card for the current chassis.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is not
bound to any chassis.
The feature card can be moved to another
chassis, or can be reactivated on the current
chassis.To reactivate on the current chassis,
enter racadm racreset until the CMC module
with the feature card installed becomes active.