User's Manual

Using the CMC With Microsoft Active Directory 187
• If DHCP is disabled on the CMC, or if DHCP is enabled but you want
to specify your DNS IP address manually, type following commands:
racadm config -g cfgLanNetworking -o
cfgDNSServersFromDHCP 0
racadm config -g cfgLanNetworking -o
cfgDNSServer1
<primary DNS IP address>
racadm config -g cfgLanNetworking -o
cfgDNSServer2
<secondary DNS IP address>
The Extended Schema feature configuration is complete.
Standard Schema Active Directory Overview
Using standard schema for Active Directory integration requires
configuration on both Active Directory and the CMC.
On the Active Directory side, a standard group object is used as a role group.
A user who has CMC access will be a member of the role group.
In order to give this user access to a specific CMC card, the role group name
and its domain name need to be configured on the specific CMC card. Unlike
the extended schema solution, the role and the privilege level is defined on
each CMC card, not in the Active Directory. Up to five role groups can be
configured and defined in each CMC. Table 5-10 shows the privileges level of
the role groups and Table 7-8 shows the default role group settings.