User's Manual

Troubleshooting and Recovery 265
To test an event trap for an alert destination:
racadm testtrap -i <
index >
where <index> is a value 1–4 representing the alert destination you want to
test. If you are unsure of the index number, type:
racadm testtrap -i < index >
Configuring E-mail Alerts
When the CMC detects a chassis event, such as an environmental warning or
a component failure, it can be configured to send an e-mail alert to one or
more e-mail addresses.
Table 11-1 provides an overview of the events that trigger e-mail and SNMP
alerts. For information on SNMP alerts, see "Configuring SNMP Alerts" on
page 260.
You can add and configure e-mail alerts using the Web interface or
RACADM.
Using the Web Interface
NOTE: To add or configure e-mail alerts, you must have Chassis Configuration
Administrator and Network Administrator privileges.
1 Log in to the CMC Web interface.
2 Select Chassis in the system tree.
3 Click the Alert Management tab. The Chassis Events page appears.
4 Enable alerting:
a Select the check boxes of the events for which you want to enable
alerting. To enable all events for alerting, select the
Select All check
box.
b Click Apply to save your settings.
5 Click the Email Alert Settings sub-tab. The Email Alert Destinations
page displays.
6 Specify the e-mail address(es) that will receive the alerts:
a Type a valid e-mail address in an empty Destination Email Address
field.
b Click Apply to save your settings.