User's Manual

Troubleshooting and Recovery 273
Using RACADM
Open a Telnet/SSH text console to the CMC, log in, and type:
racadm modinfo
Viewing the Event Logs
The Hardware Log and CMC Log pages display system-critical events that
occur on the managed system.
Viewing the Hardware Log
The CMC generates a hardware log of events that occur on the chassis. You
can view the hardware log using the Web interface and remote RACADM.
NOTE: To clear the hardware log, you must have Clear Logs Administrator
privilege.
NOTE: You can configure the CMC to send e-mail or SNMP traps when specific
events occur. For information on configuring CMC to send alerts, see "Configuring
SNMP Alerts" on page 260 and "Configuring E-mail Alerts" on page 265.
Examples of hardware log entries
critical System Software event: redundancy lost
Wed May 09 15:26:28 2007 normal System Software
event: log cleared was asserted
Wed May 09 16:06:00 2007 warning System Software
event: predictive failure was asserted
Wed May 09 15:26:31 2007 critical System Software
event: log full was asserted
Wed May 09 15:47:23 2007 unknown System Software
event: unknown event
No Value Indicates that the component is absent from the slot, or
the CMC cannot communicate with the component.
NOTE: It is not possible for the chassis to be absent.
Table 11-7. Health Status Indicators (continued)
Item Description