User's Manual

RACADM Subcommands 335
setled
NOTE: To use this subcommand, you must have Administrator privilege.
Description
Sets the state (blinking or not blinking) of the LED on the specified module.
Usage
racadm setled -m < module > -l < ledState >
Options
Table A-30 describes the setled subcommand options.
Example
racadm setled -m server-3 -1 1
LED state was set successfully.
setniccfg
NOTE: To use this subcommand, you must have Administrator privilege.
Table A-30. setled Subcommand Options
Option Description
-m <module> Specifies the module whose LED you want to configure.
<module> can be one of the following:
• server- n where n =1–16
•
switch- n where n =1–6
•
cmc-active
• chassis
-l <ledstate> Specifies whether the LED should blink.
<ledstate> can be one of the following:
• 0 — no blinking
•
1 — blinking