User's Manual

Using FlexAddress 171
NOTE: If the CMC firmware that supports FlexAddress (version 1.10 or later) is not
installed, the feature will not be activated.
See the Chassis Management Controller (CMC) Secure Digital (SD) Card
Technical Specification document for SD card installation instructions.
NOTE: The SD card contains a FlexAddress feature. Data contained on the SD card
is encrypted and may not be duplicated or altered in any way as it may inhibit
system function and cause the system to malfunction.
NOTE: Your use of the SD card is limited to one chassis only. If you have multiple
chassis, you must purchase additional SD cards.
Activation of the FlexAddress feature is automatic on restart of the CMC
with the SD feature card installed; this activation will cause the feature to
bind to the current chassis. If you have the SD card installed on the
redundant CMC system, activation of the FlexAddress feature will not occur
until the redundant CMC is made active. See the Chassis Management
Controller (CMC) Secure Digital (SD) Card Technical Specification document
for information on how to make a redundant CMC active.
When the CMC restarts, verify the activation process by using the steps in
the next section, "Verifying FlexAddress Activation."
Verifying FlexAddress Activation
To ensure proper activation of FlexAddress, RACADM commands can be
used to verify the SD feature card and FlexAddress activation.
Use the following RACADM command to verify the SD feature card and its
status:
racadm featurecard -s