User's Manual

282 I/O Fabric Management
Configuring Network Settings for an Individual IOM
The I/O Modules Configuration page allows you to configure the server
network settings for configuring and managing the IOM within the chassis.
For Ethernet switches, the out-of-band management port (IP address) is what
is configured. The in-band management port (that is, VLAN1) is not
configured using this interface.
NOTE: To change settings on the I/O Modules Configuration page, you must have
Fabric A Administrator privileges to configure IOMs Group A; Fabric B
Administrator privileges to configure IOMs Group B; or Fabric C Administrator
privileges to configure IOMs Group C.
NOTE: For Ethernet switches, the in-band (VLAN1) and out-of-band management
IP addresses cannot be the same or on the same network; this will result in the out-
of-band IP address not being set. Refer to the IOM documentation for the default
in-band management IP address.
NOTE: Only those IOMs present in the chassis are displayed.
NOTE: Do not configure I/O module network settings for Ethernet passthrough and
Infiniband switches.
To configure the network settings for an individual IOM:
1
Log in to the CMC Web interface.
2 Click I/O Modules in the system tree. Click the Setup sub-tab. The
Configure I/O Modules Network Settings page displays.
MAC Address Displays the MAC address for the IOM. The MAC address is a
unique address assigned to a device by the hardware vendor as a
means for identification.
NOTE: Passthroughs do not have MAC addresses. Only switches
have MAC addresses.
Role Displays the I/O module stacking membership when modules are
linked together:
• Member - the module is part of a stack set
•
Master - the module is a primary access point.
Table 10-2. I/O Module Health Status Information (continued)
Item Description