User's Manual

Installing and Setting Up the CMC 45
If you configure initial network settings after the CMC has an IP address, you
can use any of the following interfaces:
• Command line interfaces (CLIs) such as a serial console, Telnet, SSH, or
the Dell CMC Console via iKVM
• Remote RACADM
• The CMC Web interface
Configuring Networking Using the LCD Configuration Wizard
NOTE: The option to configure the CMC using the LCD Configuration Wizard is
available only until the CMC is deployed or the default password is changed. If the
password is not changed, the LCD can continue to be used to reconfigure the CMC
causing a possible security risk.
The LCD is located on the bottom left corner on the front of the chassis.
Figure 2-2 illustrates the LCD panel.