Reference Guide

NOTE: When the FlexAddress and FlexAddressPlus features are active, deactivating one of

them results in deactivation of the other feature also. However, ExtendedStorage is not affected

by the deactivation of FlexAddress or FlexAddresPlus.

• -r — Repair damaged/unformatted ExtendedStorage media.

NOTE: The –r switch requires that the ExtendedStorage feature be deactivated.

CAUTION: Using the -r switch reformats the SD media in the active CMC cardslot. Any existing

ExtendedStorage data will be lost.

• -c — <featurename> must be one of the following:

• flexaddress (with -d)

• flexaddressplus (with -d) ExtendedStorage (with -d or -r)

featurecard

Description Verifies proper SD card installation and displays the SD

card status.

To use this subcommand, you must have the Chassis

Configuration Administrator privilege.

Synopsis

racadm featurecard -s

Input -s — Lists active SD card features and SD card status.

Output

An example of output is given here.

racadm featurecard -s

Active CMC: The feature card inserted

is valid, serial number =

CN0H871T137401112222A00 The feature

card contains the following feature(s):

FlexAddress: bound

FlexAddressPlus: bound

ExtendedStorage: bound

Standby CMC: The feature card contains

the following feature(s):

FlexAddress: not bound

FlexAddressPlus: not bound

ExtendedStorage: bound

fwupdate

Description

Allows you to update the firmware on the active and standby CMC firmware, chassis

infrastructure firmware, and storage component firmware (RAID controller, hard disk drive, and

expander). You can:

• Check the firmware update process status.

• Update the firmware from a FTP or a TFTP server by providing an IP address and optional

path.

• Update the firmware from the local file system using remote RACADM.

• The subcommand updates one or more devices of a single type at a time.