Reference Guide

– perc-fqdd, where fqdd is FQDD of the PERC

– expander-fqdd, where fqdd is FQDD of the Storage Expander

– hdd-fqdd, where fqdd is FQDD of the HDD

• -s — Displays the current status of the firmware update.

NOTE: Use -m to display the status of the module update. Omit -m to display the status of

the active CMC update.

NOTE: Use all to get the status of all the targets that must be updated.

• -c — Cancels the current firmware update of a module.

Output

Displays a message indicating the operation that is being performed.

Example

NOTE: The following commands specifically apply to an active-CMC update.

• Upload a firmware image from the client and start firmware update:

racadm fwupdate -p -u -d firmimg.cmc

• Upload the firmware image from the TFTP server and start the firmware update:

racadm fwupdate -g -u -a 192.168.0.100 -d firmimg.cmc -m cmc-

active

TFTP firmwareate has been initiated. This update process may

take several minutes to complete.

• Upload the firmware image from the FTP server and start the firmware update.

racadm fwupdate -f 192.168.0.100 fred password123 -d

firmimg.cmc -m cmc-active

• Start IOM infrastructure firmware update.

racadm fwupdate -u -m iominf-1

• Update firmware on both the CMCs.

racadm fwupdate -g -u -a 192.168.0.100 -d firmimg.cmc -m cmc-

active -m cmc-standby

The following table describes the firmware update methods supported for each interface.

FW Update Method CMC

Local RACADM

Local RACADM - TFTP

Local RACADM - FTP

Remote RACADM

Yes

Remote RACADM-TFTP

Yes

Remote RACADM-FTP

Yes

Firmware RACADM-TFTP

Yes

Firmware RACADM-FTP

Yes

get

Description

Saves CMC Event Filter configuration to a file.