Reference Guide

• Acquires user privileges from the Active Directory

server.

• Checks the time to acquire user privileges with the

allotted time to login.

NOTE: In the event of an error, the command outputs

all tests performed up to and including the test that

failed, and all the error messages.

Synopsis

testfeature -f adkrb -u <username> [-d

<diagnostic-message-level>]

testfeature -f ldap

Description Tests LDAP configuration and operation, and reports

success as each stage of the authentication process

proceeds. After successful completion, this command

prints the CMC privileges assumed by the specified

username

If a failure occurs, the command stops with an error

message that displays the required corrective action. Use

the optional -d switch to obtain additional diagnostic

information, as needed.

Synopsis

testfeature -f ldap -u <username> -p

[-d <diagnostic-message-level>]

testtrap

Description Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRAC to a

specified destination trap listener on the network.

To use this subcommand, you must have the Test Alerts privilege.

NOTE: Before you execute the testtrap subcommand, make sure that the specified

index in the RACADM cfgAlerting group is configured properly.

Synopsis

racadm testtrap -i <index>

Input -i — Specifies the index of the trap configuration to be used for the test. Valid values are

from 1 to 4.

Example

Commands for the cfgIpmiPet group:

• Enable the alert

racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 1

• Set the destination e-mail IP address

racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIpAddr

-i 1 192.168.0.110

• View the current test trap settings

racadm getconfig -g cfgIpmiPet -i <index>

where <

index

> is a number from 1 to 4.