Users Guide

racadm config -g cfgUserAdmin -i 2 -o
cfgUserAdminEnable 1
To verify that the user was successfully added with the correct privileges, run the following command:
racadm getconfig –g cfgUserAdmin –i 2
For more information about the RACADM commands, see the Chassis Management Controller for
PowerEdge VRTX RACADM Command Line Reference Guide available at dell.com/support/manuals.
Disabling CMC User
When using RACADM, users must be disabled manually on an individual-basis. Users cannot be deleted
using a configuration file.
To delete a CMC user, the command syntax is:
racadm config -g cfgUserAdmin -o cfgUserAdminUserName
-i <index>""
racadm config -g cfgUserAdmin -i 2 -o
cfgUserAdminPrivilege 0x0
A null string of double quotation marks ("") instructs CMC to remove the user configuration at the
specified index, and then reset the user configuration to the factory default values.
Enabling CMC User With Permissions
To enable a user with specific administrative permissions (role-based authority):
1. Locate an available user index using the command syntax:
racadm getconfig -g cfgUserAdmin -i <index>
2. Type the following commands with the new user name and password.
racadm config -g cfgUserAdmin -o
cfgUserAdminPrivilege -i <index> <user privilege bitmask value>
NOTE: For a list of valid bit mask values for specific user privileges, see the Chassis
Management Controller for PowerEdge VRTX RACADM Command Line Reference Guide
available at dell.com/support/manuals. The default privilege value is 0, which indicates the user
does not has any privileges enabled.
Configuring Active Directory Users
If your company uses the Microsoft Active Directory software, you can configure the software to provide
access to CMC, allowing you to add and control CMC user privileges to your existing users in your
directory service. This is a licensed feature.
NOTE: On the following Operating Systems, you can recognize the users of CMC users by using
Active Directory.
• Microsoft Windows 2000
• Microsoft Windows Server 2003
• Microsoft Windows Server 2008
You can configure user authentication through Active Directory to log in to the CMC. You can also
provide role-based authority, which enables an administrator to configure specific privileges for each
user.
Supported Active Directory Authentication Mechanisms
You can use Active Directory to define CMC user access using two methods:
115