Quick Reference Guide
• -l - Displays the firmware versions Lifecycle Controller components.
• -f <
filter
> - Filters the components. Must be used with -1 and be one of the following values:
– bios: BIOS
– idrac: iDRAC
– usc: Unified Server Configurator (Lifecycle Controller)
– diag: 32-bit Diagnostics
– drivers: OS Driver Package
– nic-x: Network Interface card. See -l output for possible values of x.
– raid-x: RIAD Controller. See -l output for possible values of x.
• -m <
module
> - Specifies the module or device for which you must retrieve the version
information.
<
module
> is one of the following:
– server-n, where n = 1 to 4. For example, cmc-2.
– switch-n, where n = 1
– CMC-n, where n = 1 or 2
– mainboard
– perc
– expander
– hdd
– perc-fqdd, where fqdd is FQDD of the PERC.
– expander-fqdd, where fqdd is FQDD of the Storage Expander.
– hdd-fqdd, where fqdd is FQDD of the HDD.
Example
• Retrieve the version for a server 4
racadm getversion -m server-4
• Retrieve the Lifecycle Controller component versions for servers 1 and 3:
racadm getversion -l -m server-1 -m server-3
• Retrieve the Lifecycle Controller BIOS versions for servers 1 and 3:
racadm getversion -l -m server-1 -m server-3 -f bios
• Retrieve the version for all modules:
racadm getversion
• Retrieve the iDRAC version in all the servers that are attached to the chassis:
racadm getversion -f idrac
ifconfig
Description Displays the contents of the network interface table.
To use this subcommand, you must have the Execute
Diagnostic Commands or Configure iDRAC privilege.
Synopsis
racadm ifconfig
57