User's Manual

This file is updated as follows:

# Object Group "cfgLanNetworking"

[cfgLanNetworking]

cfgNicIpAddress=10.35.9.143

# comment, the rest of this line is ignored

cfgNicGateway=10.35.9.1

The command racadm config -f <myfile>.cfg parses the file and identifies any errors by line

number. A correct file updates the proper entries. Additionally, you can use the same getconfig

command from the previous example to confirm the update.

Use this file to download company-wide changes or to configure new systems over the network with the

command, racadm getconfig -f <myfile>.cfg.

NOTE: Anchor is a reserved word and should not be used in the .cfg file.

Viewing and Ending CMC Sessions

You can view the number of users currently logged in to iDRAC7 and end the user sessions.

NOTE: To end a session, you must have Chassis Configuration Administrator privilege.

Viewing and Ending CMC Sessions Using Web Interface

To view or end a session using the web interface:

1. In the left pane, go to Chassis Overview and click Network → Sessions.

The Sessions page displays the session ID, username, IP address, and session type. For more

information about these properties, see the Online Help.

2. To end the session, click Terminate for a session.

Viewing and Ending CMC Sessions Using RACADM

You must have administrator privileges to end CMC sessions using RACADM.

To view the current user sessions, use the getssninfo command.

To end a user session, use the closessn command.

For more information about these commands, see the Chassis Management Controller for PowerEdge

VRTX RACADM Command Line Reference Guide available at dell.com/support/manuals.