User's Manual

To enable and set the iDRAC QuickDeploy settings:

1. In the left pane, click Server Overview → Setup → iDRAC.

2. On the Deploy iDRAC page, in the QuickDeploy Settings section, specify the settings mentioned in

the following table. For more information about the fields, see the Online Help.

Table 7. QuickDeploy Settings

Setting Description

QuickDeploy Enabled Select the option to enable the QuickDeploy

feature that automatically applies the iDRAC

settings configured on this page to the newly

inserted servers. The auto configuration must be

confirmed locally on the LCD panel.

Enable Server Profile Deployment Select this option to enable the deployment of

profiles to newly inserted servers after

confirmation on the LCD panel, if profiles are

assigned to the slot on the Profiles page.

Set iDRAC Root Password on Server Insertion Select the option to change iDRAC root

password to match the value provided in the

iDRAC Root Password field, when a server is

inserted.

iDRAC Root Password When the Set iDRAC Root Password on Server

Insertion and QuickDeploy Enabled options are

selected, this password value is assigned to a

server's iDRAC root user password when the

server is inserted into a chassis. The password

can have 1 to 20 printable (including white

spaces) characters.

Confirm iDRAC Root Password Allows you to retype the password provided in

the Password field.

Enable iDRAC LAN Enables or disables the iDRAC LAN channel. By

default, this option is cleared.

Enable iDRAC IPv4 Enables or disables IPv4 on iDRAC. By default,

this option is selected.

Enable iDRAC IPMI over LAN Enables or disables the IPMI over LAN channel

for each iDRAC present in the chassis. By default,

this option is selected.

Enable iDRAC IPv4 DHCP Enables or disables DHCP for each iDRAC

present in the chassis. If this option is enabled,

the fields QuickDeploy IP, QuickDeploy Subnet

Mask, and QuickDeploy Gateway are disabled,

and cannot be modified since DHCP is used to

automatically assign these settings for each

iDRAC. To select this option, you must select the

Enable iDRAC IPv4 option.