Reference Guide

cfgCurrentIPv6DNSServer1
Description Displays the IPv6 address for DNS server 1.
Legal Values
Default
cfgCurrentIPv6DNSServer2
Description Displays the IPv6 address for DNS server 2.
Legal Values None
Default None
Example
racadm getconfig -g cfgCurrentIPv6LanNetworking
# cfgCurrentIPv6Enabled=1
# cfgCurrentIPv6AutoConfigWasUsed=1
# cfgCurrentLinkLocalAddress=fe80::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Address1=2009:123::e48f:9dd8:6f51:a669/64
# cfgCurrentIPv6Address2=fd88:1::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Address3=fd88:2::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Gateway=fe80::21c:23ff:fe77:6215
# cfgCurrentIPv6DNSServersFromDHCP6=1
# cfgCurrentIPv6DNSServer1=2009:123::1
# cfgCurrentIPv6DNSServer2=::
cfgNetTuning
This group enables users to configure the advanced network interface parameters for the RAC NIC or CMC. When
configured, the updated settings may take up to a minute to become active.
The following sections provide information about the objects in the cfgNetTuning group.
CAUTION: Use extra precaution when modifying properties in this group. Inappropriate modification of the
properties in this group can result in your RAC NIC become inoperable.
cfgNetTuningNicSpeed
Description Specifies the speed for the CMC NIC. This property is used
only if cfgNetTuningNicAutoNeg is set to 0.
Legal Values 10, 100, or 1000
Default 100
cfgNetTuningNicFullDuplex (Read/Write)
Description Specifies the duplex setting for the RAC or CMC NIC. This
property is used only if the cfgNetTuningNicAutoNeg is
set to 0 (disabled).
Legal Values
• 0 (Half Duplex)
• 1 (Full Duplex)
149