Reference Guide

To use this subcommand, you must have the Administrator
privilege.
Synopsis
racadm setchassisname <name>
NOTE: Chassisname is a maximum of 64 non-
extended ASCII characters.
Example
racadm setchassisname dellchassis-1
The chassis name was set successfully.
setflexaddr
Description Enables or disables FlexAddress on a particular slot or fabric.
To use this subcommand, you must have the Chassis Configuration Administrator
privilege.
If the fabric type is determined to be Infiniband, the operation is canceled and the
command returns an error. If the FlexAddress feature is not activated, the command
returns an error.
NOTE: The server must be turned off to change the slot state. All servers must be
turned off to change the fabric state. The MAC/WWN addresses must be managed
locally (not by an external console) to use this command.
Synopsis
racadm setflexaddr [-i <slot#> <state>]
[-f <fabricName> <state>]
< slot# > = 1 to 4
< fabricName > = A
< state > = 0 or 1
where 0 is disable and 1 is enable.
Input
• -i < slot# > < state > — Enables or disables FlexAddress for the specified slot.
• -f < fabricName > < state > — Enables or disables FlexAddress for the specified fabric.
Example
• racadm setflexaddr -i 1 0
Slot 1 FlexAddress state set successfully
• racadm setflexaddr -f A 1
Fabric A FlexAddress state set successfully
• racadm setflexaddr -f idrac 1
setled
Description Sets the state (blinking or not blinking) of the LED on the specified module.
To blink or unblink the chassis, I/O modules or the CMC, you must have the Debug Administrator
privilege on CMC. To enable the servers to blink or unblink, you must have the Server
Administrator or Debug Administrator privilege on CMC.
Synopsis
racadm setled -m <module> -l <ledState>
83