Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 1.35 for Dell PowerEdge VRTX
151152153154155156157158159160
NOTE: The SD card must be physically installed in CMC, and the chassis must be turned off before
running the deactivation command.
If you run the deactivation command without installing an SD card, or with a card from a different chassis
installed, the feature is deactivated and change is not made to the card.
To deactivate the FlexAddress feature and restore the SD card:
racadm feature -d -c flexaddress
The command returns the following status message if it is successfully deactivated:
feature FlexAddress is deactivated on the chassis successfully.
If the chassis is not turned off before running the command, the command throws the following error:
ERROR: Unable to deactivate the feature because the chassis is powered ON
For further information about the command, see the feature command section of the Chassis
Management Controller for PowerEdge VRTX RACADM Command Line Reference Guide.
Viewing FlexAddress Information
You can view status information for the entire chassis or for an individual server. The information
displayed includes:
• Fabric configuration.
• FlexAddress is active or not active.
• Slot number and name.
• Chassis-assigned and server-assigned addresses.
• Addresses in use.
Viewing FlexAddress Information For Chassis
FlexAddress status information can be displayed for the entire chassis. The status information includes
whether the feature is active and an overview of the FlexAddress status for each server.
Run the following RACADM command to display FlexAddress status for the entire chassis:
racadm getflexaddr
To display FlexAddress status for a particular slot:
racadm getflexaddr [-i <slot#>]
where <slot#> is a value from 1–4.
For additional information about the getflexaddr command, see the Chassis Management Controller for
PowerEdge VRTX RACADM Command Line Reference Guide.
Viewing FlexAddress Information For All Servers
To view FlexAddress status for all the servers, click Server Overview → Properties → WWN/MAC.
The WWN/MAC Summary page displays information about the following :
• WWN configuration
154