Reference Guide

SUCCESSFUL: User permissions are 0x00000fff.
testfeature -f adkrb
Description Tests the Active Directory conguration using the Kerberos authentication (single sign-on or
Smart Card login). Use the optional -d switch to obtain additional diagnostic information, as
needed. This subcommand, when run, performs the following:
• Checks command syntax.
• Veries if the required system resources are available.
• Validates Active Directory conguration.
• Veries if the SSL certicate and certicate signing request (key) exists.
• Acquires LDAP and Global Catalog Service records from DNS.
• Veries if the CMC can acquire CMC, LDAP and Global Catalog servers FQDN through
reverse IP lookups.
• Veries that the CMC principal name matches the principal name in the uploaded Keytab le.
• Veries that the CMC acquires a Kerberos TGT.
• Acquires user privileges from the Active Directory server.
• Checks the time to acquire user privileges with the allotted time to login.
NOTE: In the event of an error, the command outputs all tests performed up to and
including the test that failed, and all the error messages.
Synopsis
testfeature -f adkrb -u <username> [-d <diagnostic-message-level>]
testfeature -f ldap
Description
Tests LDAP conguration and operation, and reports success as each stage of the
authentication process proceeds. After successful completion, this command prints the CMC
privileges assumed by the specied <username>.
If a failure occurs, the command stops with an error message that displays the required
corrective action. Use the optional -d switch to obtain additional diagnostic information, as
needed.
Synopsis
testfeature -f ldap -u <username> -p <password> [-d <diagnostic-
message-level>]
testtrap
Description
Tests the RAC’s SNMP trap alerting feature by sending a test trap from CMC to a specied
destination trap listener on the network.
To use this subcommand, you must have the Test Alerts permission.
NOTE: Before you execute the testtrap subcommand, make sure that the specied
index in the RACADM cfgAlerting group is congured properly.
Synopsis
racadm testtrap -i <index>
Input -i — Species the index of the trap conguration to be used for the test. Valid values are from 1 to
4.
Example
Commands for the cfgIpmiPet group:
86