Users Guide

QuickDeploy IP address assignments for servers
The following tables show the way that the QuickDeploy IP addresses assigned to the servers based on the sleds present in the
FX2/FX2s Chassis:
● Two full-width sleds in the chassis:
Figure 3. Two full-width sleds in the chassis
● Four half-width sleds in the chassis:
Figure 4. Four half-width sleds in the chassis
● Eight quarter-width sleds in the chassis:
NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
Figure 5. Eight quarter-width sleds in the chassis
● Four FM120x4 sleds in the chassis:
NOTE: The Reserved QuickDeploy IPAddresses must be set to 16.
Figure 6. Four FM120x4 sleds in the chassis
● Top row contains only quarter-width sleds and bottom row contains only half-width sleds:
NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
Figure 7. Quarter-width sleds in top row and half-width sleds in bottom row
● Top row contains only full-width sleds and bottom row contains only half-width sleds:
Figure 8. Full-width sleds in top row and half-width sleds in bottom row
● Top row contains full-width sleds and bottom row contains only quarter-width sleds:
NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
Figure 9. Full-width sleds in top row and quarter-width sleds in bottom row
78
Configuring servers