CLI Guide

The following output example shows only part of the actual output for the racadm ? command. Descriptions shown in this example may
vary slightly from the descriptions in your racadm session.
racadm ?
help -- list racadm subcommand description
help <subcommand> -- display usage summary for a subcommand
? -- list racadm subcommand description
? <subcommand> -- display usage summary for a subcommand
arp -- display the networking arp table
chassisaction -- execute chassis or switch power-up/down/cycle or
clrraclog -- clear the CMC log
clrsel -- clear the System Event Log (SEL)
config -- modify CMC configuration properties
...
setniccfg -- modify network configuration properties
setractime -- set the time on the CMC
setslotname -- sets the name of the slot in the chassis
setsysinfo -- set the chassis name and chassis location
sslcertview -- display a CA/server certificate in the CMC
sslcsrgen -- generate a certificate CSR from the CMC
testemail -- test CMC e-mail notifications
testfeature -- test CMC feature x
testtrap -- test CMC SNMP trap notifications
traceroute -- determine the route of a packet
traceroute6 -- determine the route of a packet
Example for RACADM ? < subcommand >
racadm ? getsysinfo
getsysinfo -- display general CMC and system information
Usage:
racadm getsysinfo [-d] [-c] [-A] [-4] [-6]
-----------------------------------------------------------
Valid Options:
-d : show CMC information
-c : show chassis information
-A : do not show headers or labels
-4 : show CMC IPv4 information
-6 : show CMC IPv6 information
help and help with subcommand
Description
Lists all the subcommands available for use with RACADM and provides a short description for each.
You may also type a subcommand, group, object, or FQDD alternate name after help.
Synopsis
• racadm help
• racadm help <subcommand>
Input None
Output
• The help command displays a complete list of subcommands.
• The racadm help < subcommand > command displays information for the specied subcommand
only.
• The racadm help -g < groupname > command displays information for the specied group.
• The racadm help -o < objectname > command displays information for the specied object.
• The racadm help < FQDD Alias >.< Group > command displays information for the specied group.
• The racadm help < FQDD Alias >.< Object > command displays information for the specied
object.
• The racadm help < FQDD Alias >.< Group >.< Object > command displays information for the
specied object.
RACADM Subcommand Details 19