Quick Reference Guide

38 RACADM Subcommands
NOTE: Fabric verification for server DCs is performed only when the chassis is
powered on. When the chassis is on standby power, the iDRACs on the server
modules remain powered off and thus are unable to report the server's DC fabric
type. The DC fabric type may not be reported in the CMC user interface until the
iDRAC on the server is powered on.
Usage
racadm getdcinfo
NOTE: The example output below is for a system with multi-slot servers.
Example
• racadm getdcinfo
Group 1 I/O Type : Gigabit Ethernet
Group 2 I/O Type : FibreChannel 8
Group 3 I/O Type : Infiniband DDR
<IO#> <Type> <State>
switch-1 Gigabit Ethernet OK
switch-2 Gigabit Ethernet OK
switch-3 FibreChannel 8 OK
switch-4 FibreChannel 8 OK
switch-5 Infiniband DDR OK
switch-6 Infiniband DDR OK
<Server#> <Presence> <DC1 Type> <DC1 State>
<DC2 Type> <DC2 State>
server-1 Present FibreChannel 8 OK
Infiniband DDR OK
server-2 Not Present None N/A
None N/A
server-3 Present FibreChannel 8 OK
Infiniband DDR OK
server-4 Not Present None N/A
None N/A
server-5 Not Present None N/A
None N/A
server-6 Not Present None N/A
None N/A
server-7 Not Present None N/A
None N/A