Quick Reference Guide
RACADM Subcommands 79
Slot 1 FlexAddress state set successfully
• racadm setflexaddr -f A 1
Fabric A FlexAddress state set successfully
setled
NOTE: To use this subcommand, you must have Administrator privilege.
Description
Sets the state (blinking or not blinking) of the LED on the specified module.
Usage
racadm setled -m <module> -l <ledState>
Options
Table 2-32 describes the setled subcommand options.
Example
• racadm setled -m server-1 -1 1
LED state was set successfully.
Table 2-32. setled Subcommand Options
Option Description
-m <module> Specifies the module whose LED you want to configure.
<module> can be one of the following:
•
server-
n
where
n
=1–16
•
switch-
n
where
n
=1–6
• cmc-active
• chassis
-l <ledstate> Specifies whether the LED should blink.
<ledstate> can be one of the following:
•
0
— no blinking
•
1
— blinking