User's Manual

Using the CMC Web Interface 111
Use DHCP (For CMC
NIC IP Address)
Enables the CMC to request and obtain an IP address
from the Dynamic Host Configuration Protocol (DHCP)
server automatically.
Default: Checked (enabled)
If this option is checked, the CMC retrieves IP
configuration (IP address, mask, and gateway)
automatically from a DHCP server on your network. The
CMC will always have a unique IP address allotted over
your network.
NOTE: When this feature is enabled, the IP address,
Gateway, and Mask property fields (located immediately
following this option on the Network Configuration page) are
disabled, and any previously entered values for these
properties are ignored.
If this option is not checked, you must manually type the
IP address, gateway, and mask in the text fields
immediately following this option on the Network
Configuration page.
If you check the Use DHCP field, the software
automatically checks the Use DHCP for DNS Domain
Name field. However, if you uncheck the Use DHCP
field, the software does not automatically uncheck the Use
DHCP for DNS Domain Name field if it was checked
previously; the reason is this action is not necessary.
Static CMC IP Address Specifies or edits the static IP address for the CMC NIC.
To change this setting, deselect the Use DHCP (For NIC
IP Address) check box.
Static Gateway Specifies or edits the static gateway for the CMC NIC. To
change this setting, deselect the Use DHCP (For NIC IP
Address) check box.
Static Subnet Mask Specifies or edits the static mask for the CMC NIC. To
change this setting, deselect the Use DHCP (For NIC IP
Address) check box.
Table 5-9. Network Settings (continued)
Setting Description