User's Manual

212 Using the CMC With Microsoft Active Directory
NOTE: The bit mask values are used only when setting Standard Schema with the
RACADM.
NOTE: For more information about user privileges, see "User Types" on page 116.
There are two ways to enable Standard Schema Active Directory:
• With the CMC Web interface. See "Configuring the CMC With Standard
Schema Active Directory and Web Interface" on page 212.
• With the RACADM CLI tool. See "Configuring the CMC With Standard
Schema Active Directory and RACADM" on page 215.
Configuring Standard Schema Active Directory to Access Your CMC
You need to perform the following steps to configure the Active Directory
before an Active Directory user can access the CMC:
1
On an Active Directory server (domain controller), open the Active
Directory Users and Computers Snap-in.
2 Create a group or select an existing group. The name of the group and the
name of this domain will need to be configured on the CMC either with
the Web interface or RACADM.
For more information, see "Configuring the CMC With Standard Schema
Active Directory and Web Interface" on page 212 or "Configuring the
CMC With Standard Schema Active Directory and RACADM" on
page 215.
3 Add the Active Directory user as a member of the Active Directory group
to access the CMC.
Configuring the CMC With Standard Schema Active Directory and Web
Interface
1 Log in to the CMC Web interface.
2 Select Chassis in the system tree.
3 Click the Network/Security tab, and then click the Active Directory sub-
tab. The
Active Directory Main Menu page appears.
4 Select the Configure option, and then click Next . The Active Directory
Configuration and Management
page appears.