User's Manual

I/O Fabric Management 295
NOTE: The IP address set on the IOMs from the CMC is not saved to the switch's
permanent startup configuration. To save the IP address configuration
permanently, you must enter the
connect switch-n command, or racadm
connect switch -n
RACADM command, or use a direct interface to the
IOM GUI to save this address to the startup configuration file.
Troubleshooting IOM Network Settings
The following list contains troubleshooting items for IOM network settings:
Table 10-3. Configure I/O Module Network Settings
Item Description
Slot Indicates the location of the IOM in the chassis by group number
(A, B, or C) and slot number (1 or 2). Slot names: A1, A2, B1, B2,
C1, or C2. (The Slot value cannot be changed.)
Name Displays the IOM product name. (The IOM name cannot be
changed.)
Power State Displays the Power State of the IOM. (The Power State cannot be
changed from this page.)
DHCP Enabled Enables the IOM on the chassis to request and obtain an IP address
from the Dynamic Host Configuration Protocol (DHCP) server
automatically.
Default: Checked (enabled).
If this option is checked, the IOM retrieves IP configuration (IP
address, subnet mask, and gateway) automatically from a DHCP
server on your network.
NOTE: When this feature is enabled, the IP Address, Gateway, and
Subnet Mask property fields (located immediately adjacent following
this option) are inactivated, and any previously entered values for
these properties are ignored.
If this option is not checked, you must manually enter a valid IP
address, gateway, and subnet mask in the corresponding text fields
immediately following this option.
IP Address Specifies the IP address for the IOM network interface.
Subnet Mask Specifies the subnet mask for the IOM network interface.
Gateway Specifies the gateway for the IOM network interface.