User's Manual

320 Troubleshooting and Recovery
Using the Diagnostic Console
The Diagnostic Console page enables an advanced user, or a user under the
direction of technical support, to diagnose issues related to the chassis
hardware using CLI commands.
NOTE: To modify these settings, you must have Debug Command Administrator
privilege.
To access the Diagnostic Console page:
1
Log in to the CMC Web interface.
2 Click Chassis in the system tree.
3 Click the Troubleshooting tab.
4 Click the Diagnostics sub-tab. The Diagnostic Console page displays.
To execute a diagnostic CLI command, type the command into the Enter
RACADM Command field, and then click Submit to execute the diagnostic
command. A diagnostic results page appears.
To return to the
Diagnostic Console page, click Go Back to Diagnostic
Console
Page or Refresh.
The Diagnostic Console supports the commands listed in Table 11-11 as well
as the RACADM commands.
ERR_FWUPD_START_UPDATE_CALL 0x1428 5160
ERR_OP_NOT_CANCELABLE 0x1429 5161
BAD_FTP_USERNAME 0x142A 5162
DEVICE_NOT_AVAILABLE 0x142B 5163
Table 11-11. Supported Diagnostic Commands
Command Result
arp Displays the contents of the address resolution protocol (ARP)
table. ARP entries may not be added or deleted.
ifconfig Displays the contents of the network interface table.
Table 11-10. Firmware Update Error Codes
Error Class Error Value (Hex) Error Value (Decimal)