Reference Guide

set controllers
Description Sets the RAID controllers detected in the system and fault-tolerant mode is
configured on external controllers (Shared PERC 8 External).
Synopsis To enable fault-tolerant mode:
Racadm raid set controllers:<FQDD of controller> -p
HighAvailabilityMode ha
To disable fault-tolerant mode:
Racadm raid set controllers:<FQDD of controller> -p
HighavailabilityMode none
Input
Example
Racadm raid set controllers:<FQDD of controller> -p
HighAvailabilityMode ha
racadm raid set controllers:RAID.ChassisSlot.5-1 -p
HighAvailabilityMode ha
Racadm raid set controllers:<FQDD of controller> -p
HighavailabilityMode none
racadm raid set controllers:RAID.ChassisSlot.5-1 -p
HighAvailabilityMode none
setflexaddr
Description Enables or disables FlexAddress on a particular slot or fabric.
To use this subcommand, you must have the Chassis Configuration
Administrator privilege.
If the fabric type is determined to be Infiniband, the operation is canceled and
the command returns an error. If the FlexAddress feature is not activated, the
command returns an error.
NOTE: The server must be turned off to change the slot state. All servers
must be turned off to change the fabric state. The MAC/WWN addresses
must be managed locally (not by an external console) to use this
command.
Synopsis
racadm setflexaddr [-i <slot#> <state>]
[-f <fabricName> <state>]
<slot#> = 1 to 4
<fabricName> = A
<state> = 0 or 1
where 0 is disable and 1 is enable.
99