CLI Guide

– switch-n: where n=1–2
• -i <slot> — Must be number n, where n=1 to 4
• -v — When performing on a switch, release and renew any DHCP lease on that port for the
changes to be eective. The VLAN settings must be one of the following legal values:
– no arguments imply remove vlan tag, not compatible with server-nx. For example
(“server-4b”) notation
–
<vlan_id> 1 to 4000, 4021, and 4094 inclusive
– vlan_priority> 0 to 7, inclusive
• -p — Disables IPV4 (default)/IPV6 protocol
• -k — Must be one of the following legal values:
– no arguments imply autonegotiate
– <speed> = 10, 100
– <duplex> = half, full
• -r — Enable or disable redundant mode. The legal values are:
– 1 — Enable
– 0 — Disable
NOTE: The options -o, -k, -p, and -r can be specied for chassis
only.
• -6:
– Sets static IPv6 addresses (w/ -s option).
– Enables autocong for IPv6 (w/ -d option).
– Disables IPv6 (w/ -p option).
– Can be specied for chassis or servers.
Example
• racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1
• racadm setniccfg -d
• racadm setniccfg -d6
• Conguration of speed = 100Mbps and duplex= full duplex:
racadm setniccfg -k 100 full
• Conguration of speed and duplex to autonegotiate:
racadm setniccfig -k
• Conguration of redundant mode:
racadm setniccfg -r 1
• Conguration of VLAN id and priority of a slot or all blades in a sleeve:
racadm setniccfg -i 5 -v 1000 7
• Conguration of CMC to a static IPv6 address:
racadm setniccfg -m chassis -s -6 2001:DB8::2 64 2001:DB8::1
• Conguration of server to use stateless autoconguration address:
racadm setniccfg -m server-1 -d -6
• Conguration of VLAN id and priority for a switch:
racadm setniccfg -m switch-1 -v 1000 7
• Removal of VLAN conguration from a switch:
racadm setniccfg -m switch-1 -v
RACADM Subcommand Details
81