Users Guide
If the NTP server IP address is not congured, you may see a trace log entry similar to the following:
Jan 8 19:59:24 cmc ntpd[1423]: Cannot find existing interface for address 1.2.3.4 Jan 8
19:59:24 cmc ntpd[1423]: configuration of 1.2.3.4 failed
If an NTP server setting was congured with an invalid host name, you may see a trace log entry as follows:
Aug 21 14:34:27 cmc ntpd_initres[1298]: host name not found: blabla Aug 21 14:34:27 cmc
ntpd_initres[1298]: couldn't resolve `blabla', giving up on it
For information on how to enter the gettracelog command to review the trace log using the CMC Web interface, see Using
Diagnostic Console.
Interpreting LED Colors and Blinking Patterns
The LEDs on the chassis provide the following status of a component:
• Steadily glowing green LEDs indicate that the component is turned on. If the green LED is blinking, it indicates a critical but
routine event, such as a rmware upload, during which the unit is not operational. It does not indicate a fault.
• A blinking amber LED on a module indicates a fault on that module.
• Blue, blinking LEDs are congurable by the user and used for identication. For more information about conguration, see
Conguring LEDs to Identify Components on the Chassis.
Table 42. LED Color and Blinking Patterns
Component LED Color, Blinking Pattern Status
CMC Green, glowing steadily Turned on
Green, blinking Firmware is being uploaded
Green, dark Turned o
Blue, glowing steadily Active
Blue, blinking User-enabled module identier
Amber, glowing steadily Not used
Amber, blinking Fault
Blue, dark Standby
Server Green, glowing steadily Turned on
Green, blinking Firmware is being uploaded
Green, dark Turned o
Blue, glowing steadily Normal
Blue, blinking User-enabled module identier
Amber, glowing steadily Not used
Amber, blinking Fault
Blue, dark No fault
IOM (Common) Green, glowing steadily Turned on
Green, blinking Firmware is being uploaded
Green, dark Turned o
Blue, glowing steadily Normal/stack master
Blue, blinking User-enabled module identier
193