Owner's Manual

422 Troubleshooting and Recovery
Using RACADM
Open a serial/Telnet/SSH text console to CMC, log in, and type:
racadm getmodinfo
Viewing the Event Logs
The Hardware Log and CMC Log pages display system-critical events that
occur on the managed system.
Viewing the Hardware Log
CMC generates a hardware log of events that occur on the chassis. You can
view the hardware log using the Web interface and remote RACADM.
NOTE: To clear the hardware log, you must have Clear Logs Administrator
privilege.
NOTE: You can configure CMC to send e-mail or SNMP traps when specific events
occur. For information on configuring CMC to send alerts, see "Configuring SNMP
Alerts" on page 402 and "Configuring E-mail Alerts" on page 407.
Examples of hardware log entries
critical System Software event: redundancy lost
Wed May 09 15:26:28 2007 normal System Software
event: log cleared was asserted
Wed May 09 16:06:00 2007 warning System Software
event: predictive failure was asserted
Wed May 09 15:26:31 2007 critical System Software
event: log full was asserted
Wed May 09 15:47:23 2007 unknown System Software
event: unknown event
Using the Web Interface
You can view, save a text file version of, and clear the hardware log in the
CMC Web interface.
Table 12-9 provides descriptions of the information provided on the
Hardware Log page in the CMC Web interface.