CLI Guide

Example

racadm setchassisname dellchassis-1

The chassis name was set successfully.

set controllers

Table 119. Details of set controllers

Description Sets the RAID controllers detected in the system and fault-tolerant mode is configured on external controllers

(Shared PERC 8 External).

Synopsis To enable fault-tolerant mode:

Racadm raid set controllers:<FQDD of controller> -p HighAvailabilityMode

To disable fault-tolerant mode:

Racadm raid set controllers:<FQDD of controller> -p HighavailabilityMode

none

Input

Example

Racadm raid set controllers:<FQDD of controller> -p HighAvailabilityMode

racadm raid set controllers:RAID.ChassisSlot.5-1 -p HighAvailabilityMode

Racadm raid set controllers:<FQDD of controller> -p HighavailabilityMode

none

racadm raid set controllers:RAID.ChassisSlot.5-1 -p HighAvailabilityMode

none

setflexaddr

Table 120. Details of setflexaddr

Description Enables or disables FlexAddress on a particular slot or fabric.

To use this subcommand, you must have the Chassis Configuration Administrator privilege.

If the fabric type is determined to be Infiniband, the operation is canceled and the command returns an

error. If the FlexAddress feature is not activated, the command returns an error.

NOTE: The server must be turned off to change the slot state. All servers must be turned

off to change the fabric state. The MAC/WWN addresses must be managed locally (not

by an external console) to use this command.

Synopsis

racadm setflexaddr [-i <slot#> <state>]

[-f <fabricName> <state>]

<slot#> = 1 to 4

<fabricName> = A

<state> = 0 or 1

98 RACADM Subcommand Details