CLI Guide

Table 103. Details of raid (continued)
racadm raid
cancelrebuild:Disk.Bay.0:Enclosure.Internal.0-0:RAID.ChassisIntegrated.
1-1
racadm raid disableperc:RAID.ChassisIntegrated.2-1
racadm raid enableperc:RAID.ChassisIntegrated.2-1
racadm raid createsecuritykey:RAID.ChassisIntegrated.1-1 -key <Key id>
-passwd <passphrase>
racadm raid modifysecuritykey:RAID.ChassisIntegrated.1-1 -key <Key id>
-oldpasswd <oldpassphrase> -newpasswd <newpassphrase>
racadm raid deletesecuritykey:RAID.ChassisIntegrated.1-1
racadm raid encryptvd:Disk.Virtual.0:RAID.ChassisIntegrated.1-1
racadm raid
cryptographicerase:Disk.Bay.0:Enclosure.Internal.0-0:RAID.ChassisIntegr
ated.1-1
racadm raid unlock:RAID.ChassisIntegrated.1-1 -key <Key id> -passwd
<passphrase>
rebuild
Table 104. Details of rebuild
Description
Starts a rebuild on a specified virtual drive.
Synopsis
racadm raid rebuild:<PQ FQDD> {-current | -pending}
Input
–current <optional>: Performs the configuration.
NOTE: If this requires the system to restart, the system is restarted.
–pending: Save the configuration change for a later use. You can use a combination of the –pending and –
current flags on multiple commands to reduce the possible number of system restarts.
Example
racadm raid
rebuild:Disk.Bay.0:Enclosure.Internal.0-0:RAID.ChassisIntegrated.1-1
resetconfig
Table 105. Details of resetconfig
Description
Removes the current RAID Configuration (Virtual Drives and Hotspares) from the RAID controller. This operation is
not data-destructive, but is difficult to reverse.
Synopsis
racadm raid resetconfig:<Controller FQDD> {-current|pending}
Input
–current <optional>: Performs the configuration right now.
NOTE: If this requires the system to reboot, then the system will reboot.
–pending: Save the configuration change for a later application. You can use a combination of the –pending
and –current flags on multiple commands to reduce the possible number of system reboots.
Example
racadm raid resetconfig:RAID.ChassisIntegrated.1-1
RACADM Subcommand Details 95