CLI Guide

enableperc

Table 106. Details of enableperc

Description

Indicates the RAID configuration of hardware RAID connected to the server. This subcommand enables the power

to a RAID card.

NOTE:

• Using this subcommand will power cycle the chassis and set the fault-tolerant system

configuration to fault-tolerant mode.

• If any PERC adapter settings are changed or firmware is updated, a message is displayed and

the fault-tolerant status is degraded. Make sure that the firmware and the settings of the

SHARED PERC match to set the fault-tolerant system configuration to fault-tolerant mode.

Synopsis

racadm raid enableperc:<AdapterFQDD>

Example

racadm raid enableperc:RAID.ChassisIntegrated.2-1

disableperc

Table 107. Details of disableperc

Description

Indicates the RAID configuration of hardware RAID connected to the system. This subcommand disables the

power to a RAID card.

NOTE:

• Using this subcommand power cycles the chassis and sets the fault-tolerant system

configuration to Single PERC mode.

Synopsis

racadm raid disableperc:<ControllerFQDD>

Example

racadm raid disableperc:RAID.ChassisIntegrated.2-1

createsecuritykey

Table 108. Details of createsecuritykey

Description

Assigns a security key to the controller.

Synopsis

racadm raid createsecuritykey:<ControllerFQDD> -key <Key id> -passwd

Input

-key <Key id> — key id. The key identifier can be a minimum of one character and maximum of 32 characters.

It must not have spaces.

-passwd <passphrase> — passphrase. The passphrase can be a minimum of eight characters and a

maximum of 32 characters. The passphrase must have one character from each of the following:

• uppercase

• lowercase

• number

• non-alphanumeric character except space

96 RACADM Subcommand Details