Chassis Management Controller Version 4.
What’s New This release of CMC supports the following features: Broadcom 5719 Quad Port 1GB Blade Mezzanine Card. Expanded the CMC MIB to contain OIDs for a maximum of 32 servers in the chassis. Expanded the CMC MIB to contain OIDs for each server's Chassis Slot number, for all servers present in the chassis. Expanded the CMC MIB to contain an OID for the iKVM Version number, if iKVM is present in the chassis. Support for iDRAC7 PowerEdge M420 server.
Dell Lifecycle Controller Version: - 1.5 for Dell PowerEdge M610, M610X, M710, M710HD, M910, M915 - 2.0 for Dell PowerEdge M620, M420, M520 BIOS Version: - 1.0.0 for Dell PowerEdge M620, M420 - 6.1.0 for Dell PowerEdge M610, M610X, M710 - 5.0.1 for Dell PowerEdge M710HD - 2.7.0 for Dell PowerEdge M910 - 2.6.0 for Dell PowerEdge M915 - 2.4.0 for Dell PowerEdge M600 - 5.4.1 for Dell PowerEdge M605 - 2.3.3 for Dell PowerEdge M805, M905 Supported Web Browsers CMC version 4.
- BIOS - Lifecycle Controller - iDRAC6 NOTE: Before you update the server component firmware modules listed above, you must update CMC firmware. NOTE: To update firmware using Lifecycle Controller, iDRAC firmware must be of version 2.3 or greater. If manually updating firmware using Dell Update Packages (DUPs), the firmware should be updated in the following order: - BIOS - Lifecycle Controller - iDRAC6 NOTE: To update iDRAC firmware to 3.0 or greater from an iDRAC version less than 2.
When you add a member chassis to a chassis group using the Multi-Chassis Management feature, you cannot specify the group members with an IPv6 address. Global Support For information on technical support, visit www.dell.com/contactus. For information on documentation support, visit support.dell.com/manuals. On the Manuals page, click Software ‐>Systems Management. Click on the specific product on the right‐side to access the documents. Information in this document is subject to change without notice.