Manualshelf

Reference Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 5.20 for Dell PowerEdge M1000E
61626364656667686970
• racadm racresetcfg [-m <module>] [-c <feature>]
Input
• -m <module> — Species the device to reset the conguration on <module>. <module> must be one
of the following values:
– chassis — Default state if -m is not specied
– server–<n> — where n=1–16
– server–<nx> — where n=1–8; x=a, b, c, d (lower case)
– kvm
• -c <feature> — Must be one of the following values:
– ad — Reset Active Directory properties to default (default is disabled).
– pcap — Reset Power Cap to default.
– flex — Reset exaddress properties to default (default is disabled).
– dpse — Reset Dynamic Power Supply Engagement to default (default is disabled).
NOTE: FlexAddress or FlexAddressPlus will be set to enabled on running racadm racresetcfg
(default is enabled without –c option). The server must be turned o prior to running this
command to change the slot state.
NOTE: -c option is valid with <module = chassis> only.
NOTE: If chassis is the target of racresetcfg, CMC resets after the operation.
Example
• Reset the KVM conguration on CMC.
racadm racresetcfg -m kvm
The conguration has initiated restoration to factory defaults.
• Reset blade 8 conguration from CMC.
racadm racresetcfg -m server-8
The RAC conguration has initiated restoration to factory defaults.
Wait up to a minute for this process to complete before accessing the RAC again.
remoteimage
Description
Connects, disconnects, or deploys a media le on a remote server.
To run this subcommand, you must log in with virtual media privilege for iDRAC.
Synopsis
• racadm remoteimage [-m <module> | -a]
• racadm remoteimage -d [-m <module> | -a]
• racadm remoteimage -s [-m <module> | -a]
• racadm remoteimage -c [-m <module> | -a] [-u <username> -p <password> -l
<image_path>]
• racadm remoteimage -e [-m <module> | -a] [-u <username> -p <password> -l
<image_path>]
Input
• -c — Connect the image.
• -d — Disconnect image.
• -l — Image location on the network share; use single quotation marks around the location.
• The image path can be on a CIFS share-mounted drive or a Linux or Unix NFS-mounted drive.
CIFS share mounted path:
67