Release Notes



 Fixed an issue with Server/Host OS network port off, which occurs after CMC is reset on full-height

Modular platforms, when the second network daughter card is not installed.

 Fixed an issue causing the CMC web GUI to become unresponsive while using Active Directory

 Fixed an issue causing memory full condition when the internal log files are oversized.

 Fixed an issue causing non-display of some of the KVM-related information on the CMC web GUI.

Release 5.11

 Fixed an issue causing the health of the IOMs in slot 5 and 6 displaying "Not OK" on the CMC

Interface for chassis with an IOM installed in slot 6.

Release 5.10

 Fixed an issue with the "getmacaddress -c all” command displaying partial IO Identity values for the

Intel Dual Port Network Card 10 GBE.

 Fixed an issue with the “getmacaddress –m server-x –t iscsi” command displaying non-iSCSI MAC

addresses after using the iSCSI filter.

 Fixed an issue with flash media features displaying invalid media for active controllers after

restoring the chassis.

Release 5.02

 Fixed an issue causing CMC redundancy loss in CMC 5.0.

 Fixed an issue causing the CMC Web GUI to become unresponsive in CMC 5.0.

Release 5.01

 Upgraded OpenSSL to version 1.0.1j.

 Updated NTP to version ntp-ssl-4.2.6p3.

 Upgraded Apache to version 2.4.10.

 Fixed PS-M4110 failure to boot issue in CMC 5.0.

 When an IOM is connected through Data Center Bridging, then PS-M4110 must be configured

through its own serial port and cannot be configured through CMC interfaces.

 Fixed the power budgeting issue that occurs when SPOR is disabled.

Release 5.00

 Upgraded an open source component of WS-MAN namely Small Footprint CIM Broker (SFCB)

from 1.3.10 to 1.3.17, where CIM is Common Information Model.

 Fine-tuned memory monitoring daemons.

Important Notes

 While using Remote RACADM client with CMC 5.21 version, make sure that Remote RACADM

client version 8.0.2 is installed.

 When Certificate Validation is Enabled, FQDN of the system must be provided. If IP address of the

Domain Controller is specified when certificate validation is enabled, then the Active Directory login

does not work.

 Microsoft Windows Server 2012, Windows Server 2008 R2, Windows 7 do not support TLS 1.2 and

TLS 1.1. Install update below to enable TLS 1.2 and TLS 1.1 as a default secure protocols in

WinHTTP in Windows. For details, see the Microsoft knowledge base article 3140245 at

support.microsoft.com.

 Supports LDAP authentication with OPEN-DS. OPEN-DS must have DH key larger than 768 bits.