Users Guide

7 Click Next.
The Schedule Task tab is displayed.
8 You can either choose to apply the task immediately or schedule it to run later.
Depending on your schedule, select one of the following options:
• Run now — the power management changes are immediately applied and displays the Running status in the Task Queue.
NOTE: If the Dell client systems are not connected to the network, run the task again.
•
Run At — the power management changes are queued in the Task Queue.
NOTE: You can launch the Task Queue to view the list of completed and pending tasks.
9 Provide a brief description of the changes you are applying and click Next.
The Summary tab is displayed.
10 Click Finish.
Wipe Client Data
CAUTION: This operation deletes all the data on your client systems.
NOTE: The remote-wipe of client hard drive may take several hours to complete.
The Wipe Client Data feature remotely erases data on supported client system's hard drives.
1 Launch Dell Command | Intel vPro Out of Band.
For more information, see Launching Dell Command | Intel vPro Out of Band.
2 Click Operations > Wipe Client Data.
3 After selecting Wipe Client Data, you can perform one of the following actions:
• Schedule — to schedule a time for client system's hard disk wipe. For more information, see Scheduling Wipe Client Data.
NOTE
: To schedule a Remote Wipe Client Data operation, the client must be accessible through the network.
• Retrieve — to retrieve status of client system's hard disk wipe. For more information, see Retrieving Wipe Client Data Status.
Scheduling Wipe Client Data
The Wipe Client Data feature remotely erases data on supported client system's hard drives. To schedule a Wipe Client Data:
1 Select Schedule and click Next.
The Select Clients tab is displayed.
2 Search for client systems to which you want to schedule a remote data wipe.
3
From the Available clients list select the client systems you want to manage and click the button to move your selected systems or
press the
button to move all the discovered Dell clients into the Selected clients list.
4 Click Next.
5 The Schedule Task tab is displayed.
6 You can either choose to apply the task immediately or schedule it to run later. Depending on your schedule, select one of the following
options:
• Run now — the wipe client data operations are immediately applied and displays the Running status in the Task Queue.
NOTE
: If your client systems are not connected to the network, run the task again.
• Run At — wipe client disk operations are queued in the Task Queue.
NOTE
: You can launch the Task Queue to view the list of completed and pending tasks.
7 Provide a brief description of the Task you are applying and click Next.
NOTE
: It is recommended to run the Retrieve Wipe Client Data task to make sure that the hard drives of the client
systems have been formatted successfully. For more information see, Retrieving Wipe Client Data.
24 Using Dell Command | Intel vPro Out of Band