Reference Guide
Property Description Supported
Operating
System(s)
• .. = DMTF Reserved
DMTF has reserved the unused portion of the continuum for additional HealthStates in the
future.
LowerThresholdCritic
al
The Sensor's threshold values specify the ranges (min and max values) for determining
whether the Sensor is operating under Normal, NonCritical or Critical conditions. The
CurrentState is Critical once the CurrentReading is below LowerThresholdCritical.
Microsoft
Windows, Linux
LowerThresholdNonC
ritical
The Sensor's threshold values specify the ranges (min and max values) for determining
whether the Sensor is operating under Normal, NonCritical, Critical conditions. If Current
Reading is between LowerThresholdNonCritical and Upper ThresholdNonCritical, then the
Sensor is reporting a normal value. If CurrentReading is between
LowerThresholdNonCritical and LowerThresholdCritical, then the CurrentState is
NonCritical.
Example for Set command: wmic /namespace:\\root\dcim\sysman path
dcim_numericsensor Where ElementName like '%Temperature Sensor:%' set
LowerThresholdNonCritical =
30. This sets the all temperature probes (lower threshold
non critical) in the system to 30 degree Celsius.
Microsoft
Windows, Linux
NormalMax
NormalMax provides guidance for the user as to the normal maximum range for the
NumericSensor.
Linux
NormalMin
NormalMin provides guidance for the user as to the normal minimum range for the
NumericSensor.
Linux
OperationalStatus
Indicates the current statuses of the element. Various operational statuses are defined.
Many of the enumeration's values are self-explanatory.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = OK
• 3 = Degraded
• 4 = Stressed — Indicates that the element is functioning, but needs attention.
Examples of
Stressed states are overload, overheated, and so on.
• 5 = Predictive Failure — Indicates that an element is functioning nominally but
predicting a failure in the near future.
• 6 = Error
• 7 = Non-Recoverable Error
• 8 = Starting
• 9 = Stopping
• 10 = Stopped — Implies a clean and orderly stop
• 11 = In Service — Describes an element being configured, maintained, cleaned, or
otherwise administered.
• 12 = No Contact — Indicates that the monitoring system has knowledge of this
element, but has never been able to establish communications with it.
• 13 = Lost Communication — Indicates that the ManagedSystem Element is known to
exist and has been contacted successfully in the past, but is currently unreachable.
• 14 = Aborted — Implies an abrupt stop where the state and configuration of the
element may need to be updated.
• 15 = Dormant - Indicates that the element is inactive or quiesced.
• 16 = Supporting Entity in Error — Indicates that this element may be OK but that
another element, on which it is dependent, is in error. An example is a network service
or endpoint that cannot function due to lower-layer networking problems.
• 17 = Completed — Indicates that the element has completed its operation. This value
should be combined with either OK, Error, or Degraded so that a client can tell if the
complete operation Completed with OK (passed), Completed with Error (failed), or
Microsoft
Windows, Linux
120 Dell Command | Monitor 10.2.1 classes and properties