Reference Guide

Property Description
• 3 = Disabled
• 5 = Not Applicable
• 6 = Enabled but Offline
• 7 = No Default
• 9 = Quiesce .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
By default, the element is Enabled (value = 2).
EnabledState
An integer enumeration that indicates the enabled and disabled
states of an element. It can also indicate the transitions between
these requested states. For example, shutting down (value= 4) and
starting (value =
10) are transient states between enabled and
disabled.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Enabled — Indicates that the element is or could be
executing commands, will process any queued commands, and
queues new requests.
• 3 = Disabled — Indicates that the element will not execute
commands and will drop any new requests.
• 4 = Shutting Down — Indicates that the element is in the
process of going to a Disabled state.
• 5 = Not Applicable — Indicates the element does not support
being enabled or disabled.
• 6 = Enabled but Offline — Indicates that the element may be
completing commands, and will drop any new requests.
• 7 = In Test — Indicates that the element is in a test state.
• 8 = Deferred — Indicates that the element may be completing
commands, but will queue any new requests.
• 9 = Quiesce — Indicates that the element is enabled but in a
restricted mode. Starting (10) indicates that the element is in
the process of going to an Enabled state. New requests are
queued.
• 10 = Starting
• 11..32767 = DMTF Reserved
• 32768..65535 = Vendor Reserved
IRQLevel
An integer value that represents the IRQ level used by the parallel
port.
Pinout
The pinout used by the I/O device on this parallel port.
Possible values are:
• 0 = Unknown
• 1 = XT/AT
• 2 = PS/2
• 3 = ECP
• 4 = EPP
• 5 = IEEE 1284
• 25 = PC-98
• 26 = PC-98-Hireso
• .. = DMTF Reserved
RequestedState
An integer enumeration that indicates the last requested or desired
state for the element, irrespective of the mechanism through
which it was requested. The actual state of the element is
Dell Command | Monitor 10.2.1 classes and properties 63