Reference Guide

Property Description
elements. If the above preferred algorithm is not used, the defining entity must assure that
the resulting InstanceID is not reused across any InstanceIDs produced by this or other
providers for the NameSpace of this instance. For DMTF-defined instances, the preferred
algorithm must be used with the <OrgID>set to CIM.
LogState
LogState is an integer enumeration that indicates the current state of a log represented by
CIM_Log subclasses. LogState is to be used in conjunction with the EnabledState property
to fully describe the current state of the log.
Possible values are:
• 0 = Unknown — Indicates the state of the log is unknown.
• 2 = Normal — Indicates that the log is or could be executing logging commands, will
process any queued log entries, and will queue new logging requests.
• 3 = Erasing — Indicates that the log is being erased.
• 4 = Not Applicable — Indicates the log does not support representing a log state.
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
MaxNumberOfRecords
Maximum number of records that can be captured in the Log. If undefined, a value of zero
should be specified.
OperationalStatus
Indicates the current statuses of the element. Various operational statuses are defined.
Many of the enumeration's values are self-explanatory.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = OK
• 3 = Degraded
• 4 = Stressed — Indicates that the element is functioning, but needs attention. Examples
of
Stressed states are overload, overheated, and so on.
• 5 = Predictive Failure — Indicates that an element is functioning nominally but predicting
a failure in the near future.
• 6 = Error
• 7 = Non-Recoverable Error
• 8 = Starting
• 9 = Stopping
• 10 = Stopped — Implies a clean and orderly stop
• 11 = In Service — Describes an element being configured, maintained, cleaned, or
otherwise administered.
• 12 = No Contact — Indicates that the monitoring system has knowledge of this element,
but has never been able to establish communications with it.
• 13 = Lost Communication — Indicates that the ManagedSystem Element is known to
exist and has been contacted successfully in the past, but is currently unreachable.
• 14 = Aborted — Implies an abrupt stop where the state and configuration of the element
may need to be updated.
• 15 = Dormant — Indicates that the element is inactive or quiesced.
• 16 = Supporting Entity in Error — Indicates that this element may be OK but that
another element, on which it is dependent, is in error. An example is a network service or
endpoint that cannot function due to lower-layer networking problems.
• 17 = Completed — Indicates that the element has completed its operation. This value
should be combined with either OK, Error, or Degraded so that a client can tell if the
complete operation Completed with OK (passed), Completed with Error (failed), or
Completed with Degraded (the operation finished, but it did not complete OK or did not
report an error).
• 18 = Power Mode — Indicates that the element has additional power model information
contained in the Associated PowerManagementService association.
• .. = DMTF Reserved
Dell Command | Monitor 10.2.1 classes and properties
169