Reference Guide

Property Description
• 17 = Infiniband
• 18 = Fibre Channel
• 19 = ISDN BRI Endpoint
• 20 = ISDN B Channel Endpoint
• 21 = ISDN D Channel Endpoint
• 22 = IPv4/v6
• 23 = BGP
• 24 = OSPF
• 25 = MPLS
• 26 = UDP
• 27 = TCP
RequestedState
An integer enumeration that indicates the last requested or desired
state for the element, irrespective of the mechanism through
which it was requested. The actual state of the element is
represented by EnabledState. This property is provided to compare
the last requested and current enabled or disabled states.
Possible values are:
• 0 = Unknown — Indicates the last requested state for the
element is unknown.
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change
• 6 = Offline — Indicates that the element has been requested to
transition to the Enabled but Offline EnabledState.
• 7 = Test
• 8 = Deferred
• 9 = Quiesce
• 10 = Reboot — Refers to performing a Shut Down and then
moving to an Enabled state.
• 11 = Reset — Indicates that the element is first Disabled and
then
Enabled.
• 12 = Not Applicable
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
NOTE:
When EnabledState is set to 5 (Not Applicable),
then this property has no meaning. See the
EnabledState property description for explanations of
the values in the RequestedState enumeration.
NOTE: The value No Change (5) has been deprecated
instead of indicating the last requested state is Unknown
(0). If the last requested or desired state is unknown,
RequestedState should have the value Unknown (0), but
may have the value No Change (5). There are two new
values in RequestedState that build on the statuses of
EnabledState. These are Reboot (10) and Reset (11).
Shut Down requests an orderly transition to the Disabled state, and
may involve removing power, to completely erase any existing
state. The Disabled state requests an immediate disabling of the
element, such that it will not execute or accept any commands or
processing requests. This property is set as the result of a method
invocation (such as Start or StopService on CIM_Service), or can
be overridden and defined as WRITEable in a subclass. The method
approach is considered superior to a WRITEable property, because
52
Dell Command | Monitor 10.2.1 classes and properties