Administrator Guide

Configure IPv4 Settings
Use the Storage Manager Virtual Appliance console to modify the IPv4 network settings.
Steps
1. Using the VMware vSphere Client, launch the console for the Storage Manager Virtual Appliance.
2. Log in to the Storage Manager Virtual Appliance CLI.
3. Press 2 and Enter to display the Configuration menu.
4. Press 2 and Enter to start the Network IPv4 setup.
5. Press 1 or 2 to enable or disable DHCP, then press Enter.
6. To modify the IP address, type an IP address, and then press Enter.
7. To modify the netmask, type a new netmask, and then press Enter.
8. To modify the gateway address, type a new gateway address, and then press Enter.
9. To assign a new hostname, type a hostname, and then press Enter.
10. To modify the domain name used by the Storage Manager Virtual Appliance, type a new domain name, and then press Enter.
11. To add a new DNS server, type the IP address of one or more DNS servers. If there are multiple IP addresses, separate them with a
comma, and then press Enter.
12. Press 1 to confirm the changes and press Enter.
13. Press Enter to complete the configuration.
Configure IPv6 Settings
Use the Storage Manager Virtual Appliance console to modify the IPv6 network settings.
Steps
1. Using the VMware vSphere Client, launch the console for the Storage Manager Virtual Appliance.
2. Log in to the Storage Manager Virtual Appliance CLI.
3. Press 2 and Enter to display the Configuration menu.
4. Press 2 then Enter to start the Network IPv6 setup.
5. Press 1 or 2 to enable or disable DHCP, then press Enter.
6. To assign a new hostname, type a hostname, then press Enter.
7. To modify the domain name used by the Storage Manager Virtual Appliance, type a new domain name, and then press Enter.
8. To add a new DNS server, type the IP address of one or more DNS servers. If there are multiple IP addresses, separate them with a
comma, and then press Enter.
9. Press 1 to confirm the changes and press Enter.
10. Press Enter to complete the configuration.
Enable SSH for the Virtual Appliance
Use the Storage Manager Virtual Appliance console to enable SSH communication with the Storage Manager Virtual Appliance.
Steps
1. Using the VMware vSphere Client, launch the console for the Storage Manager Virtual Appliance.
2. Log in to the Storage Manager Virtual Appliance CLI.
3. Press 2 and Enter to display the Configuration menu.
4. Press 4 and Enter to display the SSH configuration.
5. Enable or disable SSH.
• To enable SSH, press 1 and Enter.
• To disable SSH, press 2 and Enter.
6. Press Enter.
Data Collector Management
225