Administrator Guide

Confirm the Storage Center Configuration

Make sure that the configuration information shown on the Summary page is correct before continuing. If you selected DHCP IPv4 as the

network configuration source, the dynamically assigned IP addresses are displayed on this page.

Steps

1. Verify that the Storage Center settings are correct.

2. If the configuration information is correct, click Next.

If the configuration information is incorrect, click Back and provide the correct information.

NOTE: After you click the Next button, the configuration cannot be changed until after the Storage Center is fully

deployed.

Complete the Installation

Use the Installation Complete page to connect to the Storage Center after the settings on the Summary page are applied to the Storage

Center.

Steps

Click Finish.

The Configure tab of the Initialize Storage Center wizard is displayed.

Configure Tab

Use the Configure tab to deploy the Storage Center and configure additional Storage Center settings.

• Deploy the Storage Center

• Enter Key Management Server Settings

• Create a Storage Type

• Select the Types of Ports to Configure

• Configure Time Settings

• Configure SMTP Server Settings

Deploy the Storage Center

The Initialize Storage Center wizard performs system deployment tasks.

Steps

1. (SC9000 only) To add a second controller to the storage system:

a) Select the Add Second Controller check box.

b) Type the hardware serial number of the second controller in the New Controller HSN field.

c) Type the IPv4 adddress for the management port on the second controller in the Eth0 IPv4 Address field.

d) Type the IPv4 address for the Eth1 port on the second controller in the Eth1 IPv4 Address field.

e) Type IPv6 address for the management port on the second controller in the Eth0 IPv6 Address field.

f) Type the IPv6 subnet prefix for the management port on the second controller in the Eth0 IPv6 Prefix field.

g) Click Start Deployment.

2. Wait until all of the Storage Center deployment tasks are complete.

3. Click Next.

Enter Key Management Server Settings

Specify key management server settings, such as hostname and port.

Steps

1. In the Hostname field, type the host name or IP address of the key management server.

2. In the Port field, type the number of a port with open communication with the key management server.

Storage Center Deployment