Administrator Guide

Confirm the Storage Center Configuration

Make sure that the configuration information shown on the Summary page is correct before continuing. If you selected DHCP IPv4 as the

network configuration source, the dynamically assigned IP addresses are displayed on this page.

Steps

1. Verify that the Storage Center settings are correct.

2. If the configuration information is correct, click Next.

If the configuration information is incorrect, click Back and provide the correct information.

NOTE: After you click the Next button, the configuration cannot be changed until after the Storage Center is fully

deployed.

Complete the Installation

Use the Installation Complete page to connect to the Storage Center after the settings on the Summary page are applied to the Storage

Center.

Steps

1. Click Connect.

The Unisphere interface opens in a web browser.

2. Log into Unisphere to continue Storage Center initialization:

a) Type Admin in the User Name field.

b) Type the password for the Storage Center Admin user in the Password field.

c) Click Log In.

The Configure tab of the Initialize Storage Center wizard is displayed.

Storage Center Deployment