Administrator Guide

Clear the Swap Status for a Temperature Sensor
The swap status for a temperature sensor is set when the component that contains the sensor is replaced.
Steps
1. If the Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, expand Enclosures, then select and expand an enclosure.
The Enclosure view is displayed.
4. Under the selected enclosure, click Temperature Sensor.
The Temperature Sensor view is displayed.
5. In the right pane, select the temperature sensor, then click Request Swap Clear.
Clear the Minimum and Maximum Recorded Values for
Temperature Sensor
Clear the minimum and maximum recorded values for a temperature sensor to reset them.
Steps
1. If the Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, expand Enclosures, then select and expand an enclosure.
The Enclosure view is displayed.
4. Under the selected enclosure, click Temperature Sensor.
The Temperature Sensors view is displayed.
5. In the right pane, select the temperature sensor, then click Request Min/Max Temps Clear.
Replace a Failed Cooling Fan Sensor
This step-by-step wizard guides you through replacing a failed cooling fan sensor in the Storage Center without a controller
outage.
Prerequisites
This wizard is only available for the SCv2000 series and SCv3000 series Storage Centers.
Steps
1. If the Storage Manager Client is connected to a Data Collector, select a Storage Center from the Storage view.
2. Click the Hardware tab.
3. In the Hardware tab navigation pane, expand either Controllers or Enclosures, then select and expand either a controller
or an enclosure.
Either the Enclosure or Controller view is displayed.
4. Under the selected enclosure or controller, click Fan Sensors.
The Fan Sensors view is displayed.
5. In the right pane. select the failed sensor and click Replace Failed Cooling Fan Sensor.
The Replace Failed Cooling Fan Sensor wizard opens.
6. Refer to the graphic in the wizard to locate the failed cooling fan sensor. Click Next.
7. Follow the instructions to remove the power supply from the enclosure. Click Next.
8. Follow the instructions to insert the replacement power supply. Click Next to verify the replacement.
If this verification fails, an error message is displayed. You can proceed to the next step once the error is corrected and
validated.
9. Click Finish to exit the wizard.
Storage Center Maintenance
289