Manualshelf

Administrator Guide

ManualsBrandsDell ManualsStorageDell Compellent FS8600
341342343344345346347348349350
Table Of Contents
Change the Secured Management Subnet Interface
Change the interface on which the secured management subnet is located.
Steps
1. In the Storage view, select a FluidFS cluster.
2. Click the File System tab.
3. In the File System view, select Cluster Connectivity, and then click the Management Network tab.
4. In the Management Network panel, click Edit Settings. The Modify Administrative Network dialog box opens.
5. From the Interface drop-down list, select the interface on which the secured management subnet is located.
● Select Admin to use the LOM Ethernet port for physical isolation of management traffic. You must also connect a
network cable to the LOM Ethernet port of each controller in the first (or only) appliance..
● Select Client for subnet-level isolation of management traffic.
6. Click OK.
Change the Prefix for the Secured Management Subnet
Change the prefix for the secured management subnet.
Steps
1. the Storage view, select a FluidFS cluster.
2. Click the File System tab.
3. In the File System view, select Cluster Connectivity, and then click the Management Network tab.
4. In the Management Network panel, click Edit Settings. The Modify Administrative Network dialog box opens.
5. In the Prefix field, type a prefix for the secured management subnet.
6. Click OK.
Change the VLAN Tag for the Secured Management Subnet
When a VLAN spans multiple switches, the VLAN tag is used to specify which ports and interfaces to send broadcast packets
to.
Steps
1. In the Storage view, select a FluidFS cluster.
2. Click the File System tab.
3. In the File System view, select Cluster Connectivity, and then click the Management Network tab.
4. In the Management Network panel, click Edit Settings. The Modify Administrative Network dialog box opens.
5. In the VLAN Tag field, type a VLAN tag for the secured management subnet.
6. Click OK.
Change the VIP for the Secured Management Subnet
Change the secured management subnet VIP through which an administrator manages the FluidFS cluster.
Steps
1. In the Storage view, select a FluidFS cluster.
2. Click the File System tab.
3. In the File System view, select Cluster Connectivity, and then click the Management Network tab.
4. In the Management Network panel, click Edit Settings. The Modify Administrative Network dialog box opens.
5. To change a management VIP:
a. In the Virtual IP Address field, type a management virtual IP address.
346
FluidFS Administration